[NetWork] Redundancy 상태 확인 명령

리던던시 상태 확인
Local_C4507_1#show redundancy

Redundant System Information :
------------------------------
       Available system uptime = 12 hours, 30 minutes
Switchovers system experienced = 1
              Standby failures = 0
        Last switchover reason = user forced

                 Hardware Mode = Duplex
    Configured Redundancy Mode = Stateful Switchover
     Operating Redundancy Mode = Non Redundant
              Maintenance Mode = Disabled
                Communications = Down      Reason: Simplex mode

Current Processor Information :
-------------------------------
               Active Location = slot 2
        Current Software state = ACTIVE
       Uptime in current state = 12 hours, 30 minutes
                 Image Version = Cisco IOS Software, Catalyst 4000 L3 Switch Software (cat4000-I9S-M), Version 12.2(25)EWA6, RELEASE SOFTWARE (fc1)
Technical Support: http://www.cisco.com/techsupport
Copyright (c) 1986-2006 by Cisco Systems, Inc.
Compiled Fri 02-Jun-06 15:20 by ssearch
                          BOOT =
        Configuration register = 0x2102

Peer (slot: 1) information is not available because it is in 'DISABLED' state